Phaser 8400 The image is sticking to the drum on the right side of the printer. This caused jam after jam. I have installed a new maintenace kit but still have the problem. The 8400 has a known issue ...
...jammed, that I am not finding? That is a failure in the maintenance kit tray area. 1. The Cap/Wipe/Purge belts have loosened up or are out our alignment. - Adjust the Cap/Wipe/Purge belts and follow ...
Question about Phaser 8400N Thermal Printer
Ink not being removed from metal drum, causing jam Xerox Phaser 8400...Ink not being removed from metal drum, causing paper to stick and jam printer? Normally indicates that the mintenance kit is ...
...turned off. The printer is jamming at the exit to the paper holder. The print is being left on the drum and is causing the paper to stick and adhere to the drum. I've cleaned drum completely several ...
Question about 4150V_P Printer
...you have a buildup of toner on the charge corotron. This is a part of the copier that charges the drum to accept toner. If there's buildup of toner inside or on the grid of the corotron then the ...
...jammed and is covered with ink powder. Looks like part of the reel on the left side is broken on the cylindal shaped thing. Can that part be replaced? That cylindrical thing is the drum; the drum is ...
...Drum Assembly Check for and remove any media, jammed paper, or debris found in the exit path. Did this correct the problem? Clean the Drum Maintenance Kit wiper blade or replace the kit. Did this ...
...TRAIL EDGE AND PAPER DRIVE POWER BOTH FAIL, CAN YOU TELL ME WHAT PART IT MIGHT NEED...THX Is the Drum unit clean? Often the Drum Maintenance kit can get dirty, and not clean the Drum properly, ...
...little red ( What is this for) second one paper jam and third one toner I have replaced the toner drum and this red light is still on you replaced the drum too soon, replace old drum until red
Question about Phaser 8550DX Laser Printer
...jammed paper. Re-insert the drum cartridge and toner cartridge. Replace the trays. 5. The issue may also occur due to Feeder jams. Open the tray to lower the elevator in the base of the tray ...
Usually answered in minutes!
534 Questions
436 Questions
284 Questions
267 Questions
262 Questions
