Questions & Answers for: Hyundai Sonata drive belt

belt or drive belt loose or worn. If it has tensioner, try replacing belt, if it has an adjustment to tighten, Inspect belt and if o.k. just tighten it, but I suspect belt worn too. It sounds like the

...I'm not 100% sure about the sonata, but if it is front wheel drive and your replacing the timing belt, think about replacing the water pump at the same time. That is always good practice to

...on then go off.is it the belt. It sounds like you have a loose or worn alternator belt (same belt drives water pump) That would explain the screeching noise and the battery light on when wet. Check ...

...drive belts which is connecting the crank shaft at the bottom to A/C compressor, power steering pump coolent pump and a belt tensioner. You have to loosen the belt tensioner and remove the belt. then ...

...DRIVE BELT TENSION COULD BE LOOSE WHERE BELT IS SLIPPING CAUSING BELT TO GET TOO HOT BURNING CAUSING BELT SHREADING ALSO CAUSING POOR BATTERY CHARGING CONDITIONS.HAVE THE HYUNDAI DEALERSHIP ADJUST ...

...drive belt for signs of glazing or cracking. A glazed belt will be perfectly smooth from slippage, while a good belt will have a slight texture of fabric visible. Cracks will usually start at the ...

timing belt replacement interval My rule of thumb for Timing belts: replace at 60,000 miles, and every 40,000 miles thereafter. Having said that, I often let cars go until the timing belt starts ...

...drive belt, jack up the vehicle & place it onto jack stands, then slide under the car (toss a cardboard mat down first), then, once under the car, remove the (plastic) engine splash shield.  ...

...belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models? Click the link below: ---- ...

...Drive Belt for the Alternator...See attached drawing To Remove: Raise and support the vehicle. Remove the engine splash shield. Rotate the drive belt tensioner clockwise to release the drive belt ...