Questions & Answers for: Honda drive belt

...drive belt. Here is what you do the next time you start this vehicle up and the noise is herd open the hood and pour some water on the drive belts this noise should go away or get louder temporarily. ...

...drive belt auto-tensioner on the upper part of the engine (see pic). The tensioner is an idler pulley, since it does not drive any accessory on your vehicle. Its only function is to give the belt its ...

...drive belt is loose or worn out. If the alternator is driven off a serpentine belt then replace the belt. Inspect the serpentine belt tensioner and replace if necessary. On an 18 year old car it is ...

...drive belt is routed, then use a wrench on the tensioner pulley center bolt and turn the tensioner clockwise (four cylinder engine) or counterclockwise (six cylinder engine) to release the drive belt ...

...drive belt auto-tensioner from above the engine. Slowly turn the wrench in the direction shown to release the tension, then remove the drive belt. WARNING This is a hydraulic type auto-tensioner; you ...

...the belt off or does the belt operate my power sreering also? if you look at the belt to see if it drives any other pulley other than the crankshaft pulley then you can just cut the belt off.if it ...

...drive belt I need a drive belt for a 2002 Honda Silver Wing scooter. Where can I get one for a good price? Hi, Harold the answer to this question is way above my pay grade for this situation, I would ...

...belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models? Click the link below: ---- ...

...drive belts are off my car was serviced for a blown head gasket. the garage that did the work changed the timing belt waterpump all my plugs and a new radiator. I WAS DRIVING AND ALL MY BELTS CAME ...

...drive belt back on the pulleys? The belt doesn't seem to be broken but just came off the axel pulley. Feed onto engine pulley, remove front drive pulley by removing scews holding plastic cover over ...