...drill chuck I inserted a drill bit into my Craftsman 19.2 volt drill and hand tightened the chuck. Now I can't lossen the chuck to get the drill bit out. i have the same tool and have had the same ...
Question about 6349DWDE 18V 1/2" MXT Driver - Drill Kit
...counter clockwise to release. Alternative (little WD40 on the chuck) One channel lock plier hold the chuck and put the drill in reverse. The WD40 should allow the chuck to release easier. Good
...XRP chuck is locked tight on a 1/8'' bit. Can't loosen chuck. take 2 pr of large channel locks and grab both sections of the chuck, on section in each channel lock, and use this to break it ...
Question about 3/8" Corded Drill
...drill chuck with a drill bit inside the chuck. This drill is a Sears 3/8" 31510300 Craftsman. I have used this drill many times without having this problem. I just put mine in reverse and grasp the ...
Question about DC920KA Heavy Duty Xrp 18V Cordless Drill/Driver
drill chuck stok in the thigt possition cant get the bit out ; cant make de chuck to open or close Sometimes this happens when you have a drill bit that slip. Take a pair of channel lock pliers, and ...
Question about 19.2V C3 DRILL/DRIVER
How do you remove the chuck of 18 volt cordless drill? Need to replace chuck lock an allen key in chuck,,chuck has l/h thread so turn chuck anticlockwise to remove
...hammer in counter clockwise direction. If your drill does not have spindle lock you can use Open Ended Wrench (between chuck and body) to lock spindle and then hit the allen wrench. Regards, ...
Question about 18volt 12" Cordless Drill Model P206
...chuck on this drill? You can take a pair of channel locks and grab it and turn with channel locks. The chuck consists of two parts. Hold the rear of the chuck tightly with your right hand. Take the ...
...get the chuck to release the bit it is a dewalt and yes I am in reverse On some of the DeWalt drills I have owned with keyless chucks, the chuck has a locking mechanism. You have to grip the ...
Question about 18volt 12" Cordless Drill Model P206
...whether the chuck goes clockwise or anticlockwise. Push this to the mid position which locks the chuck. Now you can insert the drill or screwdriver bit and lock the chuck by turning it
Usually answered in minutes!
227 Questions
165 Questions
160 Questions
104 Questions