Questions & Answers for: Milwaukee Tool drill

Ad

Question about Milwaukee 4206 - 1 Electromagnetic Drill Press with 3/4'' Motor

1 Answer

mag drill will not hold strong to surface When using the Mag Drill, the drill will unattach from the beam with very little pressure on the handle. What can be done to make sure that this will not ...

Ad

Question about Milwaukee 0615 - 24 14.4 Volt 1/2 Lok - Tor Drill/Driver Kit

1 Answer

I have a cordless 14.4 Milwaukee Driver/Drill that I have probably been working a too hard. When drilling with a self-feeding bit with it cranked to "drill" on the chuck, it will increasingly bog down

Ad

Question about Milwaukee 0615 - 24 14.4 Volt 1/2 Lok - Tor Drill/Driver Kit

1 Answer

Drill stopped work ing when hot. One drill we bought stopped after 10 6mm holes. The others work when you pull the trigger and then sometime they don't. Sounds like a burned out motor. Sometimes you ...

Question about Milwaukee General Purpose Screwdriver 6790 - 20

1 Answer

clutch problem on drill?? when i push in the trigger on my cordless drill the motor turns but not the chuck...i am thinking my clutchs are bad?? is that expensive to replace...the drill is a Milwakee ...

Question about 18 V LithiumIon Compact Hammer Drill

1 Answer

I borrowed my friends 18v hammer drill and I can't figure out how to change the drill bit. There is no chuck hole to unscrew and I know it's a simple trick I just don't know what to do... Hi, Grab the

Question about Milwaukee 0824 24 v18 Hammer Drill Kit

1 Answer

how do I change a bit This drill uses a keyless chuck. which means you have to hold onto the barrel by the end of the drill chuck. Then you need to put the drill in reverse to open the chuck to put a ...

Question about Milwaukee 0824 24 v18 Hammer Drill Kit

1 Answer

need to know when removing a chuck from a drill is it clockwise or counterclockwise? The retaining screw at the bottom of the chuck ( down inside where you put the drill bit) is reverse thread. the ...

Question about Milwaukee 18V 1/2 In Hammer Drill Kit 0627 24

1 Answer

Milwaukee 18V Hammer drill shuts off while drilling My hammer drill shuts off while drilling, you can release the trigger and pull again and it will restart. The holes we drill usually take about ...

Question about Milwaukee 4210-1 aka 4262-1 + 4202 Magnetic Base Drill Press

2 Answers

...ON THE MAGNET WILL TURN ON BUT WHEN I PUSH FORWARD OR REVERSE THE MAGNET LIGHT JUST BLINKS AND THE DRILL HAS TO BE TURNED OFF AND BACK ON AGAIN TO RESET THE BLINKING LIGHT. Magnetic drills have a ...

How can I fix my drill. I was drilling and it froze up on me. You can turn it one way but not the other The drill froze up. I can not get the thing that holds the drill bit to come out of the hole. It

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Milwaukee Tool Drill Experts

Mike

Level 3 Expert

4363 Answers

Harjeet Singh

Level 2 Expert

109 Answers

Domenico Grillo

Level 2 Expert

170 Answers

Are you a Milwaukee Tool Drill Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...