Questions & Answers for: Yamaha FZR 1000 drag bike

!991 FZR 1000 Idle normal when cool, High when hot(2-3,000) Just picked up this bike this month. Good Power nice response seems very well taken care of. Yosh pipe and 41,000km. Due for a valve ...

Ad

Question about 1991 FZR 1000

1 Answer

Starting problems Hi I have had starting problems after not using bike for 3 to 4 days I then replaced the spark plugs and the bike fire up first turn of the starter and was riding with much better ...

Ad

bike have problem to start when it was in the rain or after the bike was washed hi, this happens because the water enters in the engine jacket and the carburettor of the bike. check the carburattor ...

THE BIKE WIIL START RUNS SMOOTH FOR 5 TO 6 KM AND THEN WILL CUT OUT TURN OF THE BIKE AND TURN ON AGAIN THE FUEL PUMP WILL PUMP AS IF NO FUEL WAS IN THE BIKE THE CARBS WILL FILL UP AND THE BIKE WILL ...

Question about 1989 FZR 1000

1 Answer

starting problem in the rain me having yahama libero G5 bike. all the time the bike running well but when rains the bike stop running as like petrol is getting over in the mean time if you pull chock ...

HOW DO I FIND OUT WAT SIZE THE MOTOR IS ON 1995 YAMAHA STREET BIKE Here are the specs for your bike, hope his helps. According to the specs it is a 61.2 cubic inch inline four stroke. the website ...

Question about 1995 FZR 1000

1 Answer

where do I check the coolant at on my 1990 yamaha FZR 1000 There should be a coolant overflow bottle behind the side cover on the left side of the bike, near the seat. This needs to be filled to ...

...bike will not move because of the cluutch drag, if the clutch is working, it will be slightly difficult to move but it will move without the engine turning over but , other things to consider the ...

Question about 1992 FZR 1000

1 Answer

fzr1000 uses oil You likely need new valve seals (rubber seals that prevent oil in the valve area from dripping down the valves and drips into the engine as the valves open and close. This is a 300 to

...bike back and forth to bed new clutch plates in. Is this correct Back wheels often move when the lever is pulled in...this is due to hydraulic drag caused by the oil on the clutch plates and is ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...