i have a kawasaki kle 400. when i put in gear and let the clutch out the bike dont move. then when i tighten the clutch the it goes for a bit then goes again You need a new clutch basket.
when bike is ticking over it runs fine when i go to pull away the engine cuts out why is this check the side stand cut out switch is not sticking!!!
how to hot wire my ninja ex500 listen everyone knows if you wanna steal a bike just order a new ignition on ebay and take a hammer and knock out the old ignition and replace it with the new ignition ...
Good afternoon, I've just bought a 1991 KLE 500 but it doesnt have any manual with it. I'm trying to find out what the positions are for the fuel cut-off switch on the left hand side of the bike as ...
the bike has been stud outside for about a year and now will not start The bike was left for a long time, the must be discharged. 1) Charge fully the battery (if not charging change the battery) 2) ...
low voltage cannot create a spark By low voltage do you mean your battery, if not and your battery is good you will need to do a test on the coils, resistance and IB if it is neccasary, also check the
Question about 1995 KLE 500
i justgot a 95 kawasaki 500. i just cleaned the carbs and put in a fuel filter. i put bike back together. there is a black tube running out the back of the bike starting from after the carberatuor an ...
...drag when cold When bike is cold,not used for a few days it leaps forward when selecting first gear and stalls. Hold on front brake and rev and it engages ok with a klunk. the bike then rides fine ...
no spark backfire from carbs If your bike is backfiring then there must be some sort of spark as it wouldn't backfire without one. You need to check the whole starting process to see where the problem
Question about 1994 KLE 500
...Ninja 500R en500 clutch sticking from cold http://www.ex-500.com/14-engine/37908-clutch-sticking-dragging.html Kawasaki KLE500 Service ...
Usually answered in minutes!
9 Questions
5 Questions
6 Questions
5 Questions
3 Questions
