Questions & Answers for: Harley Davidson FLHT - FLHTI Electra Glide Standard drag bike

...drag. The lubricant is H-D primary lube, 40-44 ounces. Once you get the bike back on the side stand, start the engine and let it run for a couple of minutes to fill up the oil filter. Now check the ...

...hot. Now replacing shaft and want to know cause so doesnt happen again Sounds like your clutch is dragging. heat warping That is why you have to turn bike off to change gears. clutch is not ...

...bike but offered no solution. nothing to worry about unless it's causing some serious drag. it's probably that you never noticed that your brakes made some noise in the past. could just be the pads ...

...up, it expands and applies pressure to the brakes and makes them drag. Alweys test the brakes before riidng the bike. Improperly serviced brakes can cause serious injury or death. Good Luck, ...

...drag and make it impossible to find neutral with the engine running. The oil level should be no higher than the bottom of the clutch spring with the bike standing straight up. If you're experiencing ...

...bike straight up. Remove the derby cover from the primary cover. The oil level should be just up to the bottom edge of the outer clutch shell, the shiny aluminum ring. Do not over fill as the clutch ...

...drag specialty in it. i pulled the derby cover of and the smaller cover off too. i can't see the fluid looking into the derby hole due to the inner parts look to be lower than normal and close to ...