Questions & Answers for: Yamaha drag bike

Question about 2001 Drag Star Four

2 Answers

...Drag Star Four A year ago i had probs with power cutting on and off while riding, then i eventually lost all power, no dash lights , nothing Mad . The bike sat in my garage for a winter, and now im ...

Ad

Question about 2001 Drag Star Four

1 Answer

Yamaha 1998 wr400 dirtbike clutch dragging. My 1998 yamaha wr400's clutch is dragging. The oil has been replaced, the basket has been replaced, the clutch cable has been replaced, and the friction ...

Ad

Question about 2006 Roadliner Midnight

2 Answers

bike and it has a power commander because of the cobra drag pipes installed by dealer. It misses at all speeds and when trying to maintain the same speed. It sounds as though you have the wrong MAP in

...in gear and the clutch is pulled in. Got any suggestions Clutch drag. or brakes binding . all of them do it they dont roll in gear at all rrealy unless iif the bike has been running for a good ...

...drag after bike has not been used for four weeks? Clutch not fully disengaging. May, (most likely), need a fluid change in the clutch master cylinder, (on the handlebar). The wrong engine oil could ...

Question about 2003 XJR 1300

1 Answer

...drag pipes on it. The guy I bought it from dropped the bike and lost the lower extension. I bought a set of factory exhaust from ebay and put it on the bike. It sounds like a sewing machine. Will it ...

...bike back and forth to bed new clutch plates in. Is this correct Back wheels often move when the lever is pulled in...this is due to hydraulic drag caused by the oil on the clutch plates and is ...

Question about 1987 FZR 1000

1 Answer

...it wont start or turn over and when you engage the clutch and put it in first gear the back tire drags i filled it up with mystery oil and tried pop starting it but nothing ....any ideas? If the ...

Question about 1987 FZR 1000

1 Answer

Because drag pipes will lean out the air/fuel mixture, due to (much) lower backpressure. If fuel injected, then yes, some sort of piggy-back programmer is needed, or reprogramming the bike's computer

Question about 2003 TT-R 125 L

1 Answer

...it wont ? does it select when not running , select 1st and pull clutch then push the bike , does it move or drag the rear wheel ? has bike been stood a while ? any more you can tell me will help

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...