Questions & Answers for: Chevrolet Silverado 3500 door sensors

Question about 2001 Silverado 3500

1 Answer

stalls when idling engine idles down really low, electrical components die down, such as slowing of heater fan, lgts go dim, ect. then idl goes back up ( if it doesn't stall ). sounds like a map ...

Ad

2006 CHEV SILERADO 5.3LT 4 DOOR 4W DRIVE DRIVER DOOR SENSOR WHEN DRIVING THE DRIVERS DOOR SENSOR SAYS DOOR IS OPEN AND THE INTERIOR LIGHTS COME ON AND OFF AND THE DOOR LOCKS OPEN AND CLOSED WHATS ...

Ad

What size tire did the chevrolet silverado come with? it should be printed on the drivers door jamb sticker.

Question about 2001 Silverado 3500

1 Answer

I need to know where the location of the crankshaft position sensor for my 2001 chevrolet 3500 8.1L gas engine. CKP SENSOR IS LOCATED BEHIND STARTER IF ITS NOT BEHIND STARTER LOOK AROUND CRANKSHAFT ...

Question about 2001 Silverado 3500

1 Answer

going down the road but turn off then turn on it blow hot& cold sounds like a typical pneumatic door problem ...perhaps a vac. leak to the drivers side a/c door (most likely) listen for any vacumn

Question about 2001 Silverado 3500

1 Answer

I have the caliper and caliper housing off ready for the rotor to come off but it seems to be seazed on. I have beat on them like you would to normally get a rotor off but it hasnt come off yet. I am ...

Question about 2005 Silverado 3500

1 Answer

looking for factory GVW ratings for my 2005 chev HD 3500 The GVW should be listed on a plate that you can see when you open the drivers door. My 2500 is 8600 lbs GVW

Question about 2006 Silverado 3500

1 Answer

p0964 tranny jerks after vehicle gets warm, most of the time when pulling trailer with load on it. Won't change gears right (like it hangs in gear, once you turn vehicle off & restart it works

Question about 2006 Silverado 3500

1 Answer

...this truck sticks really bad> I have already replaced 2 of the manual window regulators inside the door because it is so hard to rool back up that it breaks them. Ive also loosened all the bolts ...

Question about 2003 Silverado 3500

1 Answer

IF crank sensor is unpluged will engine start i just found the plug and it was not pluged in and my truck turns over but wont start No! If the crank sensor fails the engine will not start. The ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...