Questions & Answers for: door remains locked

...door locked light remained on as did the final spin light. After a further two spin cycles the door remained locked. Turning the machine off did not work either. What can i do? door lock blown this ...

...door with a wire hanger, but the lock remains in place. The LED still reads locked and beeps regularly. Any suggestions? try turning off the circuit breaker, resetting the power sometimes trips the ...

...door remains locked, and the lights remain off. Is there a way to open the door while I wait for service? There are safety devices that can prevent you opening the door or lid while the washer is ...

...door and controls can be locked to avoid unintended use of the oven. The oven doors and controls cannot be locked if the oven is in use, or the oven temperature is 400°F (205°C) or above. The current ...

...door to close, the lock mechanism remains stuck out, the lock light on the oven is on, and all the buttons remain silent. The Frigidaire self cleaning oven, FGF355CGBF, gas range. Open the door. In ...

door lock will REMAIN locked, not unlock automatically. 3. Getting in or out of the drivers door with the keys out of the ignition the warning chime starts and continues until you close the door. With

...door remains unlocked. Not sure if is a locking problem or a programming problem as door was opened during a cycle (so clearly not locking securely) and now will not restart properly. 1) since you do ...

...door remains locked our front loader remains locked after the end of the cycle. we have attempted to run a second cycle and also were advised to place on just rinse cycle. both times, the front door ...

door lock button remains up about 1/2 inch even when locked. All other buttons are flush when locked. I then tried the emergency lock procedure described in the manual (leave both left side doors open

...door remains locked, try to reset the oven. Disconnect power to the range, and wait 30 seconds. Restore power and try again. If the door remains locked, disconnect the power and try to reset the ...