Questions & Answers for: Schlage door lock install key smooth

lock to the door. A thin flat bar is attached to the key lock that goes through the deadbolt and into the manual knob. This bar turns with the key, sliding the bolt on its track to lock and unlock the

...lock on the exterior of the door has a sticker which includes the serial number, six digit programming code and two pre-programmed four digit user codes. The lock must be disassembled to a point the ...

...lock on the exterior of the door has a sticker which includes the serial number, six digit programming code and two pre-programmed four digit user codes. The lock must be disassembled to a point the ...

lock the door, but the key will still not come out. It is stuck in the lock. Recommend resetting the lock back to factory settings and try reprogramming. Also if you don't hold the latch while turning

...lock installed on a new door. It works (able to turn it to unlock it) fine with the key inserted.... not turned just inserted on the outside. With the door open, remove the interior trim (thumb turn) ...

Hi Winston: Is it possible to try this: - pull the lock from the door while leaving the deadbolt in place - turn the mechanism 180 degrees. - re-install and give it a try. Let me know how you progress

door installed. It had a schlage lock. Can we program our other Schlage door locks so that one key fits all door? The locks are standard, not keypad. Any locksmith can do it,BUT- if you go to hardware

... When I pull up on the door then I can get the lock to line up correctly. How can I fix this? ...

...lock unlock the exterior side of the door then the interior side key turns to the point where it has to push the bolt to lock and it stops. Since it is a new install and hasn't functioned properly ...

door, i see deadbolt going into lock mode. Also, i am unable to use the key to unlock. The battery pack may be weak. They are set to stay locked as opposed to stay unlocked in case of battery failure.