Questions & Answers for: door cylinder security

Question about 2003 Impala

1 Answer

...rod. slide the lock cylinder clip out of engagement and remove lock cylinder from the door disengage the plastic clip that secures the outside handle to latch rod. remove bolts then pull it out of ...

Ad

...cylinder to door and remove lock. You will have to remove the lock from inside the door panel. Open the door and the panel should be secured with a combination of push type locks which you basically ...

Ad

door cylinder I have just purchased a '90 Accord, but the previous owner didn't have the key to lock and unlock the door. He only had the ignition key. How do I go about changing the door cylinders so

Question about 1993 Grand Cherokee

1 Answer

...WITH KEY..THIS SHOULD DISARM SYSTEM..IF YOU REPLACED DRIVER'S DOOR,THE NEW DOOR MAY NOT HAVE THE KEY CYLINDER SWITCH HOOKED UP OR NOT THERE AT ALL.THERE SHOULD BE A SMALL SWITCH ON BACK OF KEY ...

flashing. please help!!!! Pull the drivers side door panel and find the wires going to the outer door handle lock cylinder. Cut them off and strip them back and solder or crimp connector them together

...door with the key is supposed to shut down the factory security but the drivers key cylinder usually goes bad. You will have to unlock the rear tail gate lock cylinder with the key and that will shut ...

...cylinder. What is happening is the security system is not receiving the disarm signal when you unlock the door with the key. It thinks the car is being stolen so it continues to lock the lock to ...

...door using the key. I have to repeat this step 2-4 times and eventually it will start. ????????? This has nothing to do with it starting ! This is what's happening , Inside the lock cylinder are ...

cylinder was from O'Reilly and it wasn't for anti theft system I need help please Shut the hood, make sure the back hatch is shut tight. Lock all the doors. Walk around and make sure they locked. Open

...start w-blinking security Go to the driver door and try unlocking it with the key. There is a sensor on the lock cylinder (inside the door) that activates and de activates the factory security

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...