Questions & Answers for: door cable

...door the cable bends. In the long run it cuts. Previous posting was spot on .I had identical problem with my 99 sharan I removed the rubber gaiter that covers the cables between the door and the door ...

...door panel and inspect this cable. You will see 2 cables (one is for the door lock). If the plastic is broken, you will need a new interior handle assembly. Hope this is helpful!! Nissan Scope ...

...door release cable; this cable leads to the fuel door and attaches with a twist-lock connector. It is cylindrical with two tabs. Twist the connector clockwise about 90 degrees and it should pull out, ...

...door'' cable all lying in cavity on the left side of the outer tub. I think I located the ''soft drop door'' bolt mounted about 6 inches in along the bottom edge of the base frame. I assume this what ...

...door cable just turn the cable or remove the clip thats hold the cable in place or pull on that cable gas door should open after change that cable pierre If it's a lever beside the driver's seat it ...

...door. Then pop the plug out. The plug it's self is what holds the cable to the door. Do the same on the unit end. I use a putty knife because it's easier to get behind the plug. Please rate ...

...#160;I would bet that the L-shaped end of the interior door handle cable broke.  The replacement is self explanatory for the handle. Google the door lock assembly which isn't as visable. ...

...door latch cable Technical Instructions See picture below 1. Remove door trim panel and water shield per NOTE: Place a strip of masking tape along the edge of door before removing trim panel to ...

...cable from door handle. Move inner door handle to the locked position. Remove operating cable outer abutment from support bracket. Disconnect cable inner from door inner handle. Remove lock motor ...

...door panel and see if the cable fell off handle area or latch,,the cable operates the inside door handle and sometimes the outside handle but very rare that it operates the out side handle to open ...