Question about PIXMA MP780 All-In-One InkJet Printer
...and I have to manually pull the document page out of the ADF. All other printing, faxing, and paperfeeding through the ADF works fine. Have you tried lowering the resolution of the scanned
Question about PIXMA MX310 All-In-One Printer
...ADF document error message when nothing was there and all I was trying to do was print (I never fax either). So, I actually ended up having to place an actual piece of paper into the ADF slot, and ...
...ADF. Load the document with the side you want to copy, or scan face up in the ADF. 4) Adjust the Doument Guides to match the document width. Note : Ensure that the edge of the document stack is in ...
...ADF (Document Tray) Press . If a multi-page document is loaded, remove any documents other than the jammed page from the ADF, then open the Feeder Cover. Remove the jammed page from under the roller ...
Question about PIXMA MX310 All-In-One Printer
...Document in ADF. Redo operation after checking document in ADF and pressing OK". I check the ADF (it's fine) and press OK. No joy. printer just bips at me and displays error message: ...
...ADF (Document Tray) 1. First, press Stop/Reset. 2. If a multi-page document is loaded, remove any documents other than the jammed page from the ADF. 3. Then, open the Feeder Cover. 4. From under the ...
Question about PIXMA MX860 OFFICE AIO-2.5IN LCD 19.4X17.1X8.9IN All-In-One InkJet Printer
...Document in ADF press OK to discharge document Hi sdrnjen977, Here's what you can do to address the issue and clear error message: Document in ADF. If you press the Stop button during scanning, ...
Question about PIXMA MX860 OFFICE AIO-2.5IN LCD 19.4X17.1X8.9IN All-In-One InkJet Printer
...ADF carefully. If document jams occur frequently, please check the followings: 1. Do the documents satisfy paper specification? 2. Have the documents been jogged? • Align the edge of documents for ...
...document feeder (ADF) Press the Power button to turn off the printer. Disconnect the power cord from the rear of the printer. Remove any originals from the document feeder tray. Figure : Remove any ...
Question about M2727NF Laserjet Printer
document into ADF). When the document is inserted into ADF and "copy" is pressed, the ADF begins turning rollers, however the roller stays up in the air in the "ready position" while turning and doesn
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions
