where does the timing supposed to be in the ditributor cup? that is my question 3 degrees BTDC
...ditributor is remove from the engine.We camshaft and crankshaft and time is off no matching with the mark. Bring #1 cylinder to top dead center. as high as it will go. Set distributor in line with #1 ...
...new chain or belt...put it back together and litely loosen the ditributor to adjust for timing...once timing is set hold ditributor and tighten bolt. Shut down and recheck timing with the
the ditributor broke under rotor would that throw it out of time the tab under the mounting plate broke its my understanding that tells it when to fire, could that have thrown it out of time shouldn't
...ditributor but no fire While turning the engine over with a socket wrench, watch the distributor rotor and make sure that it moves immidiately as you turn the engine in either direction. If it does ...
...timing cover. Then install the distributor completely into the motor and make sure that the rotor lines up exactly with the "6" on the distributor housing. You may need to use a long screw driver to ...
...sealing to the plug, and pull off. When reinstalling, make sure that all wires are seated in the ditributor cap, they can be a little tough to get seated
...ditributor cap inside Your timing is out from the sounds of it. Not really familiar with Isuzu but basics are the same for all. Did your timing belt/chain slip/break. Did your distributor move some ...
...not start. What could be the cause? the distributor pick-up and module. get new ditributor Lots of things. Fuses, coil pack/module, starter relay, brain box, timing jumped, bad sensor of some
Question about 1996 Rodeo
ditributor, new spark plugs & hot tune up last year, it shakes when it is in park. I tried to scan it says multiple misfire. What is the year make and model of the car and also need engine size to
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions