Questions & Answers for: Jeep Grand Cherokee distributor gets loose

Question about 1994 Grand Cherokee

1 Answer

loose connections. Ignition light illuninates but nothing whatsoever happens when key is turned, lights work but not wipers or indicators. terminals cleaned. Hi there, there are numerous possibilities

Ad

...loose connection and the distributor asembly with the spurk plugs firing order.I thgink it should be 1,3,4,2.dont forget to check the ground . Also check the crankshaft position sensor by checking if ...

Ad

...distributor cap and wires. It is getting more and more frequent. Now several times a day. It could be a bad, loose or corroded ground strap from engine to chasis. has anyone told you altenators can ...

Question about 1995 Grand Cherokee

3 Answers

stating next day acts like faulty fuel pump put fuel down carb and it will start and run until I shut it off what may the problem be. Check the distributor for loose connections inside and on the coil

Question about 1996 Grand Cherokee

1 Answer

...loose wires in both places. If this all checks out, you need to test for spark and test for fuel. Make sure fuel is getting to the engine. You could spray gas or starter fluid into the carburetor. If ...

Question about 1998 Grand Cherokee

1 Answer

...loose or something disconnected. Check the air filter and housing. It may be a sensor going bad. It would be the cam sensor, unless it is built into the distributor. Anyone of these can be a ...

Question about 1998 Grand Cherokee

1 Answer

...distributor cap. Double check that the other end of the wire is firmly snapped onto the coil terminal 3. Place paper clip inside the loose coil wire end, making sure it makes contact with the coil ...

Question about 1998 Grand Cherokee

2 Answers

...loose vacuum lines and wiring as well. If you have a spare carb cleaner, have it sprayed in to the intake of the engine while revving. There might be just dirt in the system or the MAF sensor. If you ...

...distributor drive is loose, P030x means nothing the misfire codes, only tell the truth if cam drive system is NOT LOOSE. fact. on most cars i watch spark for jitter, at idle on ,most care there is ...

...distributor cap, rotor, module and spark ignitor coil and no luck. Checked for spark by taking loose a spark plug wire and using a sc won't start. Parked it one day, next day it wouldn't start. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...