engine turns, distributor doesn't I have no idea what engine, but the cause is the same for all engines, #1 cause is the timing belt or chain is broken/damaged, #2 the distributor driven gear is ...
key is broken off in the ignition switch how can i get it out of the switch You'll have to take the whole ignition piece out in order to remove the broken key. I apparently jammed a bunch paper clips ...
Will crank won't turn over it's not my batt. An it Will crank wont turn over not my batt. Seems to be getting gas just died while in park check for spark and see if its getting fuel these should be ...
...will be the same. Your exhaust may not bolt right up depending if you're using headers or not. The distributor will be the same as the small block. The guage hook ups will be pretty close to the ...
...balancer for TDC if you are going to time this engine with a timing light after you get the distributor back in. Rotate the engine backeard about 6º to 10º. Rotate the distributor
...my car will not turnover, its not the battery and i just recently put new spark plugs,wires,rotor,distributor cap, ignition module and coil and my car doesnt turn over it cranks hard but doesnt
just replaced a dead battery with a brand new one. Tried starting it and it makes a high pitch whining sound and wont start. Any suggestions of what the problem is? Does it need to sit to charge the ...
i have a 350 chevy engine using a mallory unilite distributor what is the spark plug gap for champion platinum plugs number 3025 the engine is 1978 Without any more information than this I have to say
i have a 1949 chevy truck,,i need to know how to set the timing on the distributor? Can anyone help? you need a timing light and there is a bolt that holds the distributor to the motor and if you undo
how do you time a 2005 Chevrolet classic 2.2 Ecotec There is no distributor so ignition timing can not be changed or adjusted.
Usually answered in minutes!
25 Questions
7 Questions