Questions & Answers for: Chevrolet Caprice Classic distributor gets loose

Question about 1995 Caprice Classic

1 Answer

...tool set. But that's the gist of it. Drain the fluids, remove the oil pan, loosen and raise the distributor, pull off the oil pump, clean as needed, put in the new one, replace the seals and ...

Ad

Question about 1995 Caprice Classic

1 Answer

eletrical i have a 1995 caprice classic with the 4.3 liter v8. And have replaced the coil,distributor,and ignition module and now i cant find the wire that connects the distributor to the engine ...

Ad

Question about 1994 Caprice Classic

1 Answer

...Boys they ran a diagnostic test and said the car needed a tune up. So we replaced the plugs, wires, distributor cap and distributor,IGN coil, Gas filter, air filter, oil change and the water pump ...

Question about 1994 Caprice Classic

1 Answer

How do Install a distributor on 1994 Chevrolet caprice to instal the distributor you need to have number one cylinder on top dead center . on compression stroke. Then when you put the distributor in. ...

Question about 1995 Caprice Classic

1 Answer

car is out of time....cause trying to change the distributor cab, by mistake the crantshaf was moved and now the timing in the chevy is out of line If you only replaced the distributor cap and did not

Question about 1994 Caprice Classic

2 Answers

...or simply check under the hood to see if your distributor has come loose. If you havent adjusted your timing lately and your distributor isnt loose its time to get that timing belt or chain

Question about 1994 Caprice Classic

2 Answers

i want to know how to remove the pick up coil from my 1991 caprice distributor in a 305 engine Hi, In order to remove the pick up coil, the distributor must be removed, once out, take the roll pin out

Question about 1994 Caprice Classic

1 Answer

car will not start put distributor in the car If the dist was removed it has to be put back into the same location-to redo it, remove the dist and crank the engine around to #1 TDC (timing marks on ...

...distributor itself, you may have dislodged the tan wire or the connection to the oil pressure switch, or by some fluke the pressure switch failed.   Check for stray wires, damaged wires, or ...

when i bolt on the new distributor on a 1995 caprice lt1 4.3 is there away it has to be done like set to number like you do with the old style everybody keeps telling me no but it just doesnt make ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...