Questions & Answers for: Chevrolet Blazer distributor gets loose

...Gets worse if it's really humid/damp (cold is fine). Was thinking possibly rotor/distributor but then recently (this happened twice in about a 2 week span) I started it and most of my dummy lights, ...

...distributor). all my spark plugs are secure, and so are the wires. The exhaust smells very rich. Almost like my old 2 stroke yamaha dirtbike, with no exhaust. I have no check engine light. I know it ...

on torq converter 2 for motor mounts. The 2 at the top of bellhousing behind distributor are a bear to get, Also the bellhousing might be stuck on the doll pins, you may need a pry bar to pop it loose

...gets its signal to fire from the pick-up located inside the distributor if you are loosing injector pulse only the ignition module is bad if you are also loosing spark when you loose injector pulse ...

to start but wont its getting fuel and spark what could be roung? timing could be off check to see if timing belt is broke or if the distributor on back of motor is wet and or maybee loose and turning

...distributor snug but loose enough to turn until that code stops coming up.Once you get that code to quit coming up tightened the distributor down completely. There should be a timing mark on the ...

...loose but they are not what else could i check Replace the distributor cap and rotor button. And dont get a cheap cap, get a oem one or it will just happen again. they are known for burning through ...

gets gas on plugs,distributor was loose,good spark on plugs.Plugs back in- turns over hard.Repaced starter,same problem.Checked timing chain,marks both up,balancer at 0deg,distributor at #1. What else

...loose on the distributor shaft. The other issue is a worn distributor gear, you will notice a lot of freeplay when you try rotating the distributor rotor back and forth.Last but not least, spray the ...

distributor cap, battery, fuel pump and sending unit. Cranked and ran good for 2 days now will not crank. Getting spark and gas but will not start Check you starter, maybe you have a loose connection.