Questions & Answers for: Honda distributor gets loose

...Loose wire http://www.tegger.com/hondafaq/startproblems.html this should help. The other problem could be the main relay: http://www.tegger.com/hondafaq/mainrelayoperation/badmainrelay.html this ...

...distributor and pushed it back on, and it started. After getting it home, it wouldn't start again. This morning I took the wire loose from both ends, checked for shorts. firmly put both ends back on, ...

loose i pulled it out a little then push it back in and the car shut off i try to turn the car back on and it would not start i change the spark plug wires and cap i can hear the fuel pump working but

loose distributor rotor if not check if you have fuel pressure. if you don't get any spark see if you are getting power to the distributor one of the side wires has to have 12v whit the key on run. if

...distributor cap is loose, will my car turn off? last time i was driving on the freeway, and out of now where my car turned off and wouldnt turn back on. After a couple of hours, i saw the distributor ...

what is the correct procedure to check and correct the distributor timing. you have to use a timing light and the timing should be 4% - top dead center. point the light at the crank pulley with motor ...

...loose. If you see nothing obviously wrong, the igniter may have given up the ghost. This is part of the distributor assembly and you have to buy a complete distributor to get it. The igniter can be ...

...loose ? With the distributor cap removed have someone turn over the engine, while you check rotor arm is turning! If memory serves me right! The keyway use to ring on them.... plus the rotor its self ...

...distributor. Read OBD codes. See link how to. https://honda-tech.com/forums/honda-accord-1990-2002-2/90-93-accord-obd1-cel-codes-2630683/ check and test the wiring and connections for ...

...loose, which could cause the camshaft to jump and misalign the distributor gear. It may be helpful to consult with a mechanic or engine specialist to diagnose and address the issue. Here are a few ...