Questions & Answers for: GMC distributor gets loose

Question about 2005 Sierra 1500 Hybrid

2 Answers

...start when hot This deffinently sounds like your ignition module, it is located on the side of the distributor generally hald on by two screws. This is a very common thing with Chevy / GMC. Good

Ad

...gets its signal to fire from the pick-up located inside the distributor if you are loosing injector pulse only the ignition module is bad if you are also loosing spark when you loose injector pulse ...

Ad

...distributor. mark the rotor to base location so it wont loose timing and ur truck will start instead of stutter after your done. remove distributor (small screw on base of distributor) and youll get ...

Question about 1998 Sierra

1 Answer

...distributor cap rotor button no luck getting fuel smell it listen to see if you can hear the fuel pump running in feul tank. if running then check electronic fire box to make sure it it not loose,if ...

...loose from the distributor shaft. It's pressed onto it from the factory. To tell if yours is loose just try to turn the rotor by hand when the distributor is installed. If it does, you need a new ...

distributor was loose tryed to adjust it but gets close but still want start help please Turn the distributor to where it fires the best, snug it down slightly then remove the cap. look inside the cap

Question about 1986 S-15

2 Answers

...distributor cap/rotor the screw might have been stripped some or just loose. And yes over a period of time they can work them self off, mostly because the rotor itself is the moving part. The ...

...Put your CRANK to ZERO and then put a screwdriver into the hole to see where the Line is and then align the Distributor that way, then you need to keep it loose so you can get the timing down

Question about 1993 Sierra K1500

1 Answer

...distributor all the way down leaving the keeper loose to align rotor to the number one spark plug wire on the cap . install wires to spark plugs .next have someone crank the engine while you are ...

Distributor. Unplug the electrical connection and remove the 2 screws holding it in place.( I believe these should be small torque bits) Then once it is loose you'll have to line it up with the square

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,225 Questions

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

2003 GMC Envoy
2003 GMC Envoy

1,368 Questions

2002 GMC Envoy
2002 GMC Envoy

1,418 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...