Questions & Answers for: distributor gets loose

Ad

...loose distributor is the any other causes and what happens when distributor loose If your distributor is lose than you need to check the timing. Pull a plug out and put the plug wire back on it. ...

Ad

...loose. check the distributor, there should have a seal ring where the cap goes. the ring should be inbedded in the distributor housing. Make sre the seal is good, and the distributor is not

Ad

...distributor cap is loose, will my car turn off? last time i was driving on the freeway, and out of now where my car turned off and wouldnt turn back on. After a couple of hours, i saw the distributor ...

...Loose bearing/bushing in distributor body. (The shaft that the rotor screws down to, goes through a bearing, or bushing, in the distributor casting) See if you get excessive axial run-out of this ...

...distributor. mark the rotor to base location so it wont loose timing and ur truck will start instead of stutter after your done. remove distributor (small screw on base of distributor) and youll get ...

distributor vibrated loose ,lost spark ,wont start how do i fix ?The distributor just turns loosely in the engine the bolts that hold it in place vibrated loose easy to sort out ,turn engine around so

Question about 1984 Maxima

1 Answer

...distributor shaft gets worn out or the rotor button and the cap go bad. check for a loose dist, drive shaft also ! this is probably why it will not start, because of no spark. if dist shaft is loose ...

...back in same order and rotor. do not know what I did wrong. There must be something loose. Check that it's getting power form the battery side and triple check all the connections to the

Parked at home and waiting for advise. If you can determine the ignition system is ok, I would look at fuel pressure and the fuel filter. If the distributor was loose you may have to check base timing

Question about 1984 Maxima

3 Answers

...did you last check the plugs, distributor, plug wires. Any one can cause problem Those distributors get a lot of heat and vibration. Check all wires inside distributor and coil for loose

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...