Questions & Answers for: Danby digital thermometer reads

...reads upside down and I cannot change the temp. It just beeps and goes back and forth from C to F. Also when I screwed in the CO2 tank and turn it on it leaks air from where you screw into the tank. ...

SETTINGS DCF520W I JUST BOUGHT A USE UNIT AND NOT SURE WHAT NUMBER TO SET AT FOR MEAT? The best temperature for storing food is 0 degrees F. I would go to Wal-Mart, K-mart or a dollar store and find a

on my danby refrigeator by turing the temp gauge from high to low is low the coldest NO.low is the warmwest,i use a thermometer to run my fridge at +3C to+5C.that way you dont get black lettuce.......

I set the temperature and soon the blinker starts blinking lo lo lo lo NOTE: This is a multi-solution answer since I don't have all the tech from your question to pinpoint your problem But the ...

Ambient thermometer seems incorrect The displayed ambient temperature of the room is reading much cooler then the room actually feels. It seems to correlate more with the outdoor temperature then with

digital display read 47 degrees, while a thermometer inside read 30. Check for corrosion on the temp probe. The digital displays use thermistors to determine the temp so if the probe has dust on it it

I get a lot of temp variance. A thermometer on the top shelf shows 40 degrees. A thermometer on the lower shelf shows 32 degrees. This is a lot of variance. Is this normal? if the door has been opened

Our Danby 38 bottle wine cooler.. just purchased used..checking temps in both sections..neither one is on targeted temp..out a few (4 or 5) degrees each..is it possible to re-calibrate these units at ...

Danby Silhouette DBC7070BLSST. Temp zones are flashing Hi, fridge is warm. Unplugged and plugged back in. Worked well for 12 hours. Then Temp zones are Hi, fridge is warm again. Any ideas? check ...

My Danby fridge model DFF100C2BSSDD, the bottom shelf vegetables keep freezing and noticed some frost at the vents on upper shelf. Increase the temperature inside by turning the knob anticlockwise. ...