dash are supposed to work, all it does is nothing. When turned to start all you hear nothing. I installed a new ignition switch and it worked good for a day now it is doing the same thing My 400 has a
Question about 2005 Magnum 330 4X4
I have no lights no dash and when I turn the key over nothing battery is good Have the ignition module unit tested, I had one go bad and it did the same thing. Eric
...ignition wiring seeing where i could plug my new dash cover in and now none my lights wont work, still starts and runs tho but no lighting?? Hi Brandon Use a 12v multimeter or a test light to trace ...
Question about 2004 Big Bear 400 4x2
...ignition switch to electrcal harness This should be a straight plug connector to plug connector. no two should fit the same connector, really easy!! Its inside the headlight or under the dash
Question about 2004 Big Bear 400 4x2
...ignition dash lights head lights, winch but will pull start First check the positive cable at battery and at the starter relay that the positive wire usually goes to. Somewhere right around there ...
Ignition on, dash has lights, won't crank No power to starter solenoid or spark Well, my first two "guesses" would be either your battery is nearly dead (but still enough juice to power dash lights), ...
Question about 2007 Grizzly 450 Auto 4x4
...dash light (switch power)... and starter's ignition (temporary power) are different contacts and terminal on the ignition switch. If you DO HAVE a RELAY... and the SOLENOID test above worked clean up ...
Question about 2007 Grizzly 450 Auto 4x4
...when I turn on the ignition switch the hot wire gets very hot also dash quit working Don't know if wireing to solenoid is correct never seen one with fuse on it YOU + WIRE GROUNDING OUT SOME
...it. No lights on dash either. I traced wires and all are good. Any ideas Need to test to see if power is being sent from the key switch to the ignition I would think bad fuse or bad ignition ...
Question about Polaris ATV
...dash, the ignition switch and the fuses even though the fuses were all good. Sounds like a short or one of main sensors is burned out.. Mite get a voltage meter and see if your getting Power or not. ...
Usually answered in minutes!
2,486 Questions
168 Questions
72 Questions
99 Questions
61 Questions