Questions & Answers for: Flotec cyclone 12 speed

flotecpump runs for 5 minustes or less and shuts down due to overheating running on 2 12gauge wire harnesses approx 250ft from power source 12-2 cords combined into 2 to 1 splitter to combine them at ...

flotec 1/2 hp pump won't run. 124v line voltage. But L1 to L2 shows -00.1 to -00.4 Power supply line is 12/2 to a on/off switch and 14/2 to pump from switch. Distance to service is less than 100 feet ...

I have the FPOF 360 AC model - 1/12 HP 350 gal/hr. The motor is working, but it is not suctioning any water. Thanks. Karen I would take a drill and drill an eighth inch hole in the discharge pipe of ...

i replaced a one horse flotec sprinkler pump with a 1 1/2 horse pump. the one horse was wired at 115 volt/ 20 amp 12 gauge wire. the new pump is blowing the breaker.any suggestions ? Your best ...

I have a Flotec 1/2 hp jet pump. Is it posible to get just the pump housing. Mine froze cracked the housing? Use Google and put in Flotec parts. I did that and several parts dealers came up. Pick one ...

just borrowed this pump - how do I hook it up? just borrowed this pump - how do I hook it up? Which side (hose) goes in water to be pumped? if you look on the fitting area where the hoses connect to -

flotec 1/12 sprinker pump runs 5 sec. and trips breaker Hi, The pump is seized up... you can try to open it and get it spinning... make sure that there is nothing stuck in the impeller... other then ...

I have 2 flotec cyclone pumps. Both need impellers. Where can I get them? I don't need a whole repair kit. Just the impellers. I just need the impellers, not a whole rebuild kit. Where can I get just ...

have new impeller but pump will not pump Did you find the piece of impeller or pieces of impeller broken off. May be clogging system up. Need to back flush system to make sure clear. 

Motor hums a few seconds before it kicks on sounds like ur fuel pump loading