...Lacks power Clean the air filter and spark arrestor (muffler). Try turning the "H" needle 1/8 turn CCW and retry. no better turn it CW 3/16 and try again. This is a very good adjustment explanation. ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...lines for decay or other damage. Make sure the carburetor fasteners are tight. Turn both jet screws CW to stops (lightly), then back out CCW 1-1/2 turns each. This is a basic setting which should ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...a poulan Titanium chain saw, what is the carb ajustment? Thanks Douglas Neil Turn both jet screws CW to stops (lightly), then back both out 1-1/2 turns CCW each. This is a basic setting and the ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...o.k. until my neighbor made a mistake and movved the adjustment screw. Turn both H and L screws CW to stops (lightly), then CCW out 1-1/2 turns each. This a basic setting and the engine should ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...how to adjust the two gas intake screws to insure proper gas to air intake. Turn both jet screws CW to stops (lightly), then back out each CCW 1-1/2 turns. This is a basic setting that will allow ...
Question about Pro 16-Inch 38 cc Anti-Vibration Chainsaw #PP3516AVX
How to adjust a macCullouch 110 chain saw carb? Turn both jet screws CW to stops (lightly), then back out each CCW 1-1/2 turns each. This is a basic setting which should allow the engine to start and ...
Question about Pro 16-Inch 38 cc Anti-Vibration Chainsaw #PP3516AVX
...on a Poulan 38cc chainsaw? Someone has messed with the low and high adjustment Turn both jet screws CW to stops (lightly), then back out CCW 1-1/2 turns each. This is a basic setting and the engine ...
...that the diaphragm controls for any damage or wear. If still flooding, turn both needle jet screws CW to stops (lightly), the back each out CCW 1-1/2 turns. This is a basic setting which should
...SETTINGS FOR 40CC POULAN CHAIN SAW Make sure the air cleaner is not plugged. Turn both jet screws CW to stops (lightly), then back each out 1-1/2 turns CCW. This is a basic setting and should allow ...
...are not plugged. Make sure the fuel lines are not decayed or other damage. Turn H and L jet screws CW to stops (lightly), then back CCW 1-1/2 turns each. This is a basic setting that should allow
Usually answered in minutes!
583 Questions
457 Questions
255 Questions