...sunfire 2.4 gt,axle went in and won't come back out go to a parts store and use there loaner tool program, get the cv shaft removal tool, this tool will help you get that baby out,,, good luck
What size is the axle nut on the cv joint on a 1998 pontiac sunfire? I remove with a 29 mm. thaty is the perfect size but 1 3/16 socket will also do the job.
...cv joint off the end of the axle shaft in order to get the new boot on how do i do it? i am replacing the inner cv boot and cant get the cv joint off what do i do. thank you the following sites r ...
...the job. Yes even doing the work yourself (very difficult) can cost $100-200. A shop will charge $400-??? the whole cv-axle is not that much, but the labor may be. you can get it done as low as ...
...axle...cv joint did not go in all the way...still like about an inch? Would remove it and try to reposition it.There is a clip at the end of the axle that sometimes will stop it from going in all the ...
...CV joint boot on the axle. The boot holds grease to lubricate the CV, and when the boot is torn, the grease comes out, causing a click or grind. I;m assuming this issue is not brake related of
...axle from the transaxle, pry on the cv joint housing with a large screwdriver or a pry bar. You may need to give the pry bar a sharp rap with a brass hammer. (or a rubber mallet) Check out the ...
turn left or right make noise If its a popping or clicking noise when turning wheels, it could be cv axle.
steerring when turning wheel to left hear popping sound fromunderneath,not so much when turned to right,sounds as if pivoting point may be dry sounds like cv axle is worn out
Question about 2000 Sunfire
...way you turn. They only knock or click when they have been completely worn out. When I diagnose a CV axle, they both get replaced. Just because I have to take both sides apart to find the bad CV
Usually answered in minutes!
987 Questions
731 Questions
699 Questions
696 Questions
696 Questions