Questions & Answers for: Buick Century cv axle

...CV joint become worn, it all depends on how long the boot has been ripped, its easier and a lot less messy to R/I new axle. For the wheel bearings they need to be pressed in by a hydraulic press. As ...

Ad

...axle, Once CV is cleaned and repacked with grease rintall onto axle by again spreading apart clamp. Prior to installing CV joint slide NEW CV joint boot onto axle, Cleanly intall add'l grrease and ...

Ad

Question about 2000 Century

2 Answers

...cv joint You need to break the bottom ball joint loose ,in most cases,after removing the axle nut. then pull the axle and replace with a reman from an axle specialty suppler or auto part store. best ...

...It dosen't do it every time only ocasionally. 2004 Buick century 117,000 miles.6cyl. The inner cv joints / axles. About 175 a piece plus labor ,wheel alignment approx

Question about 2004 Century

1 Answer

...cv axle instead of trying to just replace the boot, if the grease leaked out and dirt got into the joint then the joint is bad in soon you will hear noise or joint will let go. the time it take to ...

Question about 1998 Century

2 Answers

...CV axle is worn out, replace it "Knocking" noise when turning may be caused by a bad stabilizer link bushing or a worn lower ball joint. To test, simply raise the left front wheel by placing the jack ...

Question about 1998 Century

2 Answers

...cv axle gone bad its best to change both of them to save you time at a later date if you dont beleave me jack the car up put stands under the vehicle put the car in drive and watch the axles turn and ...

Question about 1998 Century

2 Answers

cv axle replacement cost I just bought a used 2004 Buick Century. I have noticed a "knocking" when turning. My brother said that it sounds like bad CV axles. I am going to get them replaced within the

Question about 1998 Century

1 Answer

...CV Axle bearings... Bad CV axles are expected to click but they can also on rare occasions squeak... I know because I had that experience with a 1984 Sentra when doing a U or close turn only. Other ...

...axle nut does a 2002 buick century need? Theres a grinding in the front left wheel. Sounds like you need to change a hub and bearing assembly big nut can be either 34 or 36 mm, bolts on rear 13 or 15 ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...