...deck not cutting level Air pressure, deck height ,sharp blades are all correct but when I cut and especially on a right turn the deck cuts deep on the left side. IS this deck too thin and that causes ...
to adjust deck If the mower has been cutting fine in the past, and you do not see anything loose on the deck between the deck and the chassis. I would check the air pressure in each tire. HTH Good Day
Question about 42 in. Deck 19.5hp Lawn Tractor
...cutting uneven. It was not the deck, the blades, the wheels, or the deck height adjustment. It was cutting uneven because in order for a mower to blow air out, it has to draw air in. The area where ...
Question about 20 hp 42 in. Deck Lawn Tractor - CA Model
...deck and its attachment points are not bent or damaged. 5. Drive at a slow walking speed with the engine at cutting speed. 6. Over lap rows in amounts sufficient to lift and cut the tire tracks from ...
...deck, 1 blade is cutting lower than the other Check that the cutting tip of the blade that is cutting lower is not bent down. Also park the mower on a level surface and lower the deck and check the ...
...lower now. The deck is slowly dropping lower and lower. Any ideas as to what would cause this. If you have removed the cutting deck for any reason you may have put the deck arms in the wrong
Question about 195HP Hydrostatic 42" Cut Riding Mower
...cutting deck 3 blades replaced and the deck was then put back in place but now the problem is the cutting deck disengages in down cutting position and engages in the deck up position. Check your ...
Question about STT61V-27CH Hydrostatic, Gas Turf Tiger Zero Turn
...cutting height. Push forward on the deck lift foot lever, hold in place and pull back on the deck release lever. Slowly release the foot pedal. A deck height decal is located on the cutting height ...
problems cutting deck wont disengage, starts with cutting deck engaged Your deck either engages with a cable or an electric clutch, which one is it. Cutting deck engaged when started is a switch issue
Question about STT61V-27CH Hydrostatic, Gas Turf Tiger Zero Turn
...cutting deck on a lr 135 I've stripped down my cutting deck to renew it when I got to the piece out the blade bolts to I couldn't part them to fit through the hole where it bolts onto so I cut it out ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions