Questions & Answers for: crown ce1000 power amp

Crown CE1000 the right channel on my amp is not working at all Cuold be the final power amp ic. Might be imput transistors to that channel. Its possible to have a cold solder joint on pcb.Look close ...

Crown CE1000 My fan does not work, I bought it used and I recall it was working when I had used it earlier. Also, channel one would not play abd then three days later it was fine just no fan... Wavey ...

...Crown CE1000 power amplifier. I turned it on the other day and I seen a bright flash inside of it. Now the fault lights are blinking and it won't work. Is there something that I can look for or is it ...

...Crown CE1000 Amps 2 Yamaha 15 pa loud speakers (non powered) 2 Jbl 15 pa loud speakers (non powered) 1 18 Yamaha Sub (non powered) Behringer crossover Behringer 1204fx mixer email: [email protected] ...

Crown CE1000 amps, 1 dead channel - Can I diagnose via RJ-45? I have 2 Crown CE-1000 amps, each of which has 1 dead channel. Is there any way a tech-savvy, non-repair person can use the ...

CROWN CE1000- slips into fault immediately after connection CROWN CE1000- powers up fine, goes through fault protection testing fine, but unit clips and slips into fault protection (cycling) ...

...CE1000 does not come on when the amp is powered up. The amp seems to be playing normally, but I am afraid I may over heat the amp if the fan is not working. Is this normal? The Thermal Senser on the ...

how many amps ? To determine the current draw (assuming near-unity power factor), divide the input power wattage printed on the back of the amplifier by the line voltage.

CE1000. On the back there are the red and black 2 prong inputs for speakers as well as the other larger round speaker connection under that. I was wanting to connect 2 Yamaha speaker and a powered JBL

schematic diagram ce1000 crown amp busted power amp section Here's a link to the service manual from Crown: http://www.crownaudio.com/media/pdf/legacy/130352-1_10-02_ce1-2_serv_revd.pdf