Crown CE1000 the right channel on my amp is not working at all Cuold be the final power amp ic. Might be imput transistors to that channel. Its possible to have a cold solder joint on pcb.Look close ...
...CE1000 crown amp in for repair. Where can I send it? Typing "amp repair" in google should get you a fairly comprehensive list. I fixed a couple of my amps recently which had blown transistors. These ...
Question about CE1000 2-Channel Amplifier
...Crown CE1000 power amplifier. I turned it on the other day and I seen a bright flash inside of it. Now the fault lights are blinking and it won't work. Is there something that I can look for or is it ...
...Crown CE1000 Amps 2 Yamaha 15 pa loud speakers (non powered) 2 Jbl 15 pa loud speakers (non powered) 1 18 Yamaha Sub (non powered) Behringer crossover Behringer 1204fx mixer email: [email protected] ...
Should the fan run when my crown ce1000 unit is turned on, or is it automatic? It runs in response to certain thermal conditions.
...crown ce1000 -should the fan come on later when the amp heats up? This is a very sophisticated amp and it will turn the fan on at various speeds when it feels the need for it. Of course, if it's ...
Question about CE1000 2-Channel Amplifier
CROWN CE1000- slips into fault immediately after connection CROWN CE1000- powers up fine, goes through fault protection testing fine, but unit clips and slips into fault protection (cycling) ...
fan running I just bought a crown ce1000 -should the fan come on later when the amp heats up? Yes, many of the pro sound amps throttle the fan based on an internal temperature sensing device.
I NEED SCHEMATIC DIAGRAM OF CE1000 Hi, I think this is what you wanted. Thanks, gylacz
schematic diagram ce1000 crown amp busted power amp section Here's a link to the service manual from Crown: http://www.crownaudio.com/media/pdf/legacy/130352-1_10-02_ce1-2_serv_revd.pdf
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions