Questions & Answers for: crankshaft pulley bolt

Question about 1992 Accord

Honda accord ex 92

...Crankshaft pulley (harmonic balancer) removal- disconnect neg battery cable, remove belts, it would be a good idea to soak the bolt w/ penetrating oil overnight, there is a special 'crankshaft pulley ...

Question about 1997 Camry

2 Answers

Looking for timing mark's for a 1997 camry with a

...Crankshaft pulley bolt [4]. Crankshaft pulley [5]. Use tool No.09213-60017. 5. 6. Ensure timing marks aligned [2] & [3]. 7. Slacken tensioner bolt [6]. Move tensioner away from belt and lightly ...

Question about 1997 Camry

1 Answer

Hiwich timing mark I used to time the balancer

...crankshaft pulley and bolt. Rotate crankshaft pulley counterclockwise several times to seat belt. Loosen adjusting nut 1 turn. Rotate crankshaft counterclockwise 3 teeth on camshaft pulley. Tighten ...

Question about 1996 Camry

1 Answer

Procedure in changing timing belt

...crankshaft pulley, then slide the pulley on. Install the No. 2 idler pulley with the bolt and tighten to 31 ft. lbs. (42 Nm). Be sure the pulley moves smoothly. NOTE: Remove any oil or water on the ...

Question about 1993 Camry V6

1 Answer

Como poner la banda de tienpo de un toyota camery

...crankshaft pulley bolt, rotate crankshaft so timing mark on crankshaft sprocket aligns with timing mark on oil pump housing. See. This will position keyway in crankshaft sprocket at 12 o'clock ...

Question about 1997 TL Series

1 Answer

1997 acura tl crankshaft spinning freely, is this

crankshaft pulley and a/c pulley/belt rotate normally when a/c is not engaged. Once engaged, crankshaft pulley is slipping. Please help CHECK SEE IF CRANK SHAFT PULLEY BOLTS LOOSE.IF CRANKSHAFT PULLEY

Question about 1998 Legacy

1 Answer

How many foot pounds of torque should i tighten the bolt that holds on the harmonic balance on a 1996 subaru legacy outback

...crankshaft pulley. 2) Install the pulley bolt. To lock the crankshaft, use ST. ST 499977400 CRANKSHAFT PULLEY WRENCH (1) Clean the crankshaft pulley thread using an air gun. (2) Apply engine oil to ...

Question about 1997 Outback

1 Answer

Torque specs

Question about 2002 Sportage

1 Answer

Please could you give me a diagram of the valve timing of a double O.H.C.on a toyota Rav4 3SFE engine

...crankshaft pulley bolt, turn the crankshaft and position the key groove of the crankshaft timing pulley upward. If reusing the timing belt, align the points marked during removal. Install the timing ...

Question about 2006 Range Rover Sport

1 Answer

How do you remove the crankshaft dumper pully?

...Crankshaft Pulley In-vehicle Repair Special Tool(s) Holding Tool Crankshaft Pulley 303-893(LRT-12-080) Adapter 303-191-03 Bolts and spacers 303-191-04 Remover, crankshaft pulley 303-588 Remover, ...