Questions & Answers for: Nissan Sentra crankshaft

front crank seal slight leak 1998 nissan sentra hi!replace the crankshaft oil seal.most of nissan's vehicles use timing chain so just remove the drive blets and the crankshaft pulley.use a screw ...

Crankshaft position sensor for 2004 Nissan 1.8 eng. Location of the sensor on the engine? Can you tell me? \bob/ This sensor is located at the crankshaft pully . the sensor is mounted on the block

where is the crankshaft sensor located at The crankshaft sensor on the 1.8 and the 2.5 are located on the back of the engine near the starter motor.

...be wrong and also were is the fuel filter located on that model car. You might want to check the crankshaft and camshaft sensers, there has been issues with the factory ones over heating and ...

where is the crankshaft sensor located ? where is the crankshaft sensor located ? The crankshaft position sensor (POS) is located on the oil pan facing the gear teeth (cogs) of the signal plate. It ...

...plate installation-CA16DE and CA18DE engines Fig. Fig. 6: A spacer must be installed between the crankshaft and pulley bolt head before rotating the engine-CA16DE and CA18DE engines Disconnect the ...

how do u set timing on it? 1.8 engine Installation Install crankshaft sprocket on crankshaft. Make sure mating marks on crankshaft sprocket face front of engine. Position crankshaft so that No. 1 ...

...pulley The timing marks must be lined up with the center of the camshaft and the center of the crankshaft. the same goes for the crankshaft timing marks. All the marks and the shaft centers ...

crankshaft positioning sensor Here's a link,just enlarge to see where the crankshaft position sensor is.Here's what it look's like.

WHERE IS THE CRANKSHAFT LOCATED CANT FIND CRANKSHAFT The crankshaft is located towards the bottom of the engine. If you look at the side of the engine, look for the largest pully. The crankshaft is ...