...rotor, alternator, battery, mass sencer. What next? timing position sensor on the block or at the crankshaft pulley.If not the computer is most likely ...
... The power-train (ECM) supplies a 12-volt reference circuit and a low reference circuit to both the crankshaft position (CKP) sensor and the camshaft position (CMP) sensor. The CKP sensor sends a ...
...and the pump relay switch... what eles would you recommend checking or looking at? have you checked crankshaft position sensor? located on side of the harmonic balancer (crankshaft pulley), unclip ...
engine wont start. has no computer codes,has fuel pressure and spark battery is ok and turns over fine Then you either have a faulty camshaft or crankshaft sensor.
coil. the module checked out fine. What is next to check? did you check for a crank signal from the crankshaft sensor? the sensor is located near the balancer on the front of the engine
Question about 1997 Safari
...gmc safari. Starts sometimes and doesn't other times. Fuel pump tests fine, new fuel filter and crankshaft sensor. Can't afford to keep doing process of elimination. Throwing out codes P0101 ...
my safari 1991 have not spark the car dosent start, no spark check for crankshaft sensor or camshaft sensor,or immobilizer ,or ignition switch failure- use the spare key.
Question about 1996 Safari
...It acts like it wants to turn over but then stutters out, I'm thinking it's the Crankshaft sensor or the Camshaft sensor. Or possibly both of them. It ran fine after I changed ...
p1336 gm code Need location and what the code means. P1335 CHEVROLET P1335 CHEVROLET - Crankshaft Position Circuit Possible causes - Faulty Crankshaft Position Sensor - Crankshaft Position (CKP) ...
Question about 1994 Safari
1994 GMC Safari. Where is the CKP (Crankshaft Position) Sensor location on it please? replacement ckp Question edited for a lot more clarity. Question moved to model category. This says it doesn't ...
Usually answered in minutes!
316 Questions
254 Questions
265 Questions
207 Questions
197 Questions