...for exhaust and a notch above it on the valve cover align those marks.Last you have a notch on your crank sprocket, align that notch with the arrow just above it.Align all marks then turn belt to ...
...To assist with removing the bolts, you will want to put a large socket on the crank and turn it to move the belt and rotate the pulleys. The pulley in the top of the diagram has ...
how do u adjust the timing i must have moved the pullies when i was putting on the timing belt after i changed the water pump now its not runnin smooth its off how do i put it back in time There are ...
..., take a test light and test for power at the starter signal wire while someone turns the key to crank this is the small gauge wire going into starter,if there is no power at this wire it will not ...
...crank handle retaining clip on the back side of the window crank handle. Using your trim panel removal tool, apply pressure to the window crank handle retaining clip to remove the crank
...crank handle retaining clip on the back side of the window crank handle. Using your trim panel removal tool, apply pressure to the window crank handle retaining clip to remove the crank
...#1) If your can has non-interfering valve, you could pull off the valve cover, and have a helper crank the engine and see if all the valves are moving smoothly up and down and have the same travel
Question about 2001 Spectra
When trying to set timing to replace belt the crank locks what would be problem you are allowing the pistons to lock up on the valves that are open. Remove the cam shaft/s and then set the crank ...
1.8l. How do I replace front seal? 1. remove all the fan belts on the main (crank shaft pulley) 2. Lose the bolt of the pulley, Use a puller to remove the pulley (if neccesary) 3. Use a screwdriver to
Usually answered in minutes!
796 Questions
637 Questions
326 Questions
298 Questions
292 Questions