Questions & Answers for: GMC Yukon crank removal

Crank senor Hi, how do I find my crank senor The crank sensor is on the front( bottom) of the engine behind the crank pulley, the pulley will have to be removed to access the sensor. It is the largest

...after sitting a very long while, more than a grocery shop, etc) it will not start on the first crank. It DOES typically start readily after the second crank. These cranks are typical in length ...

if the alarm had remote start. Is to let know the alarm that the car is on, so it won't continue to crank the starter. If you have no problems with the Yukon you can eliminate the wire

...the terminals for 12 volts with ignition on position.if getting 12 volts.you have PCM PROBLEMS OR CRANK POSITION SENSOR..IF GETTING NO 12 VOLTS YOU GOT A BLOWN FUSE OR GROUNDING

...gmc Yukon i just changed the fuel pump spark plugs ing coil control module wires but she still wont crank she starts then shuts off whats wrong HEPL ME PLZ I suppose that you mean it starts but ...

...serpentine first then the a/c belt , it has it's own tensioner. Just remember to take it off the crank pulley first and tuck it behind between the motor and pulley or you will be all day trying to ...

leave it loosely lay over the plug(do not hold on to it with your hand or you will get shocked) and crank the motor and listen for a sharp snap noise or have someone else crank it while you listen for

...Removal & Installation To Remove: Remove wiper arms. Remove weatherstrip from cowl. Remove two cowl vent grille panel screws. Remove windshield nozzles and hoses. Remove three cowl vent grille ...

My 96 yukon wil not start. Sounds like it will crank over but won't. It is not the fuel. I changed the ignition coil still won't start. try spraying some carb cleaner into a vaccum hose and ...

i replaced cap rotar and dist. now it cranks over but will not fire and is back firing the timing is off a bit! heres how I do it. remove the number 1 plug, stick a straw or similar in plug hole. turn