...removal of the crank pulley (5 small bolts), and pull the pulley off the crank. Contrary to what the manauls say, the problem is the clearance between the crankshaft pulley and the frame will not ...
...like it is coming from the timing belt cover. need some suggestions as to what it could be front crank ...
door pannel removal i can get all the screws out but its stuck on the window crank the crank will pull off. Very few cars you can pull off crank top and find screw underneath to remove crank.
...anything else yet because I just got her. Thanks You will have to pull the engine and remove the crank shaft and connecting rods you have a bad rod bearing. I will strongly suggest taking to a ...
...detected and at 3900 rpm it will start stutering and not go past it. I am thinking maybe the crank or camshaft position sensor? Hopefuly not the computer. Any suggestions? check plugs and
oil leak, looks like the timing cover. front crank seal is bad
Engine cranks slowly and barely starts Cranks very slow to start then runs rough for about 10 seconds, then purrs like a kitten. Help! fuel problem?timming?tune up?
I have 137,000 miles on a 3 cyl. 1998 metro, It stopped running going down the expressway, there's no spark and the cam stills turns when cranking over. Two days before I put a new o-2 senor on and it
2000 1.3l chevy metro cam and crank shaft position sensor resistance 00 chevy metro 1.3l just replace head gasket and had head work new timing belt timing/compressing good reassembled adjusted valve ...
Question about 2000 Metro
I have a 2000 Chevy Metro 4 cyl 1.3...I just replaced the rod bearings and now the car won't crank. It will turn over but not start.I have already checked the timing and its in time. Any suggestio
Usually answered in minutes!
95 Questions
76 Questions
69 Questions
67 Questions