Questions & Answers for: Oldsmobile crank removal

Question about 2000 Intrigue

1 Answer

crank position sensor location i have a 2000 olds intrigue and i need to replace the crank position sensor and i cannot locate it can anyone help me thanks you will need to remove the starter to gain ...

Ad

how hard should it be to get to the crank shaft does anyone have any instructions on how to get to the crank shaft to replace crank sensor on 1995 oldsmobile eighty eight, and should it be will ...

Ad

Question about 1990 Cutlass Ciera

1 Answer

crank shaft pulley how hard is it to replacing the crank shaft pulley Not too hard if you have a pulley puller. Remove the belt, remove the crank shaft bolt, pull the crank pulley off, then reinstall ...

how to remove window crank handle can not remove window crank handle on 2003 alero there is a clip that hold in the handle.you need to pop it out with a 90 degree pick tool There is actually a tool ...

where is the crank sensor on a 1994 olds 88? The crank sensor is located behind the crank pulley. it has to be lined up perfectly when replaced. You will understand when you remove the crank. Check ...

How do you change the crank shaft pulley? If you have the 3.5l engine, and you don't remove the right side engine cradle bolts, you will not have enough room and will strip out the bolt when you go to

Question about 2000 Intrigue

1 Answer

crank position sensor were is the crank postion sensor located It is on the front of the motor under the manifold, you have to remove the starter first then it is right there on the block. make sure ...

...if it runs out of the cylinder. Notice if it comes out of all or just one. With the plugs removed, crank the engine over to see if it will crank over or just clunk again. If antifreeze is present ...

I have to remove the window crank to take off the door panel. How do I remove the crank I did not see any fasteners that hold it on yet I can pull it off there is a special tool for removing the ...

...if there is one fit a harmonic balancer remover puller pull the balancer of Note take care in the removal as there may be a crank sensor at the balancer best get a workshop manual for photos on the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...