Question about 2002 Intrepid
...removal is not necessary. Pull the old belt off. If the crank are in time, they will not rotate. TDC (and 6-7 o'clock) is a natural resting place. If they are out of time, have someone hold the cams ...
...crank removal? hi there, im looking to remove my door panel on a 2000 chrysler neon and im not sure how to remove the window crank. i took out all the screws, but im not sure how to get the panel off ...
...fly if you don't keep be careful. clip tools are at most auto parts store-by slighty spreading the door crank look down and you will see spring clip.Note it's either nut removal or spring
...timing belt, distributor cap and rotor all good. Any ideas? 3.9 v6 These trucks are known for there crank position sensors to go bad. You will have to remove your belts, Remove the crank pulley ...
where is the crank sensor on engine Most of your crank sensors are mounted near the harmonic balancer that is mounted to the crank shaft.Its usually held on with one or two mounting screws and has an ...
Question about 2002 Grand Caravan
my van was running and it just turned it self off now it wont start again it just clicks in the fuse pannel Are your headlights bright or check voltage ar battery with lights on or with someone ...
how to replace crank sensor The crank sensor will be one of two places. Either it will be at the front crank pulley/vibration damper or at the rear at the top of the transmission housing where it ...
How to change crank sensor? no power, no spark at all you can find it on lower passenger side rear next to bellhousing housing ,check all wires before removing ,if removing , remove the 3 wire plug ...
How to remove and replace a crank sensor for a 1994 Dodge Ram 5.2 Should be a bolt holding it in .remove and replace. Video shows location. It's in a hard place to get to, and some report it's easier ...
Question about 1993 Ram
2012 dodge charger 3.6 engine cranks but will not start. check engine code p0339 was diagnosed. Replaced crankshaft position sensor but still not able to start. it cranks though. Remove and inspect ...
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions