Questions & Answers for: Chevrolet crank removal

Question about 2001 Metro

1 Answer

door pannel removal i can get all the screws out but its stuck on the window crank the crank will pull off. Very few cars you can pull off crank top and find screw underneath to remove crank.

Ad

Question about 1998 S-10 Pickup

1 Answer

crank removal tool, but the shaft size is larger than the slot on the tool. Their must be different size tools for different vehicles...also the clip is very close to the crank handle and not possible

Ad

looking for the location of the crank position sensor and the knock sensor for a 2001 chevrolet silverado with a 4.8 8cylinder engine Crank sensor; right (pass.) side of block above the starter. You ...

crank removal (window crank on mostly earlier models) You can start at a bottom edge with what i recommend a door panel removal tool-most auto parts store carry these. even if a clip falls out you can

...removing the water pump, dropping the oil pan, removing the balancer and timing cover. Rotate the crank so the dots on the cam gear and crank gear line up at the 6 and 12 o clock positions ...

...REMOVAL PROCEDURE Remove the wiper arms. Remove the air inlet grille panel. Disconnect the electrical connector from the motor. IMPORTANT: Do not remove the crank arm. Loosen the nuts attaching the ...

when motor is cold will not crank.when i put cleaner for throttle body in area around throttle body,it cranks.after truck cranks,i can crank it again and again.only when motor is cold it will not ...

...VAN IT QUIT WHILE DRIVING. I TRIED TO START BACK BUT BATTERY WENT DEAD, SO I GOT A BOOST, IT WOULD CRANK BUT NOT START. I GOT BATTERY TESTED IT WAS NOT HOLDING ENOUGH CRANKING AMPS SO I BOUGHT NEW1. ...

How to replace the rear main crank shaft seal Nothing but add 3 quarts of oil a week. oil is coming out between engine and transmission and it is engine oil. You will have to pull the engine unless ...

How to replace a stripped window crank on a 1997 Chevy Lumina? The window crank is held in place by a locking clip. Remove the clip and pull the crank off the shaft. If the crank is stripped, just ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...