Questions & Answers for: Volkswagen Golf crank pulley

pulley. the crank has to be top dead centre as well with the cam lined up. TDC has a line on the flywheel. to see the line remove the plastic covering on the gearbox. best thing is to remove the spark

...crank seal since you have to take the outter pulley off anyways and the only other thing is to make sure the idler pulley is in good condition, I've had one seize up on me in a 1.8L and it wasn't fun ...

...crank and power steering pump (if equipped). Then, a smaller belt goes around the A/C compressor and around the alternator. If it's a diesel, there will also be a tensioner pulley for the alternator ...

...crank pulley 6mm allens not the 19mm 12 bolt make sure timing belt is still at TDC remove lower timing belt cover there is 3 bolts and a nut holding it on the nut is by the water pump and the bolts ...

...crank bolt will be on the lowest pulley on the back of the engine where the belts run. It is usually about a 19mm bolt. Warning: turn only clockwise and never counterclockwise. If you can turn the ...

...crank shaft pulley, replace steering pump, replace A/C, put small belt on A/C (hang loose) put large belt around A/C, Main and water pump pulley. put middle size belt on Main water pump and power ...

also notch on crank pulley will line up with arrow on timing cover.check position of rotor arm ,lineup with relevnt plug lead on cap this is no1 work clockwise round the cap lead order will be 1-3-4-2

...crank pulley with nail polish or some paint at 0 degree and then turn your timing light on while the engine is running and adjust distributor to advance or ****** the ignition timing. Usually its ...

...remove the crank pulley to access the water pump bolts no u do not have to deal with crank pulley. Here is a DIY very useful ...

...are out oftiming hi.you have to get your marks lined up with the bottom crank pulley stil on because your bottom mark is on the pulley and on youre timing belt dust cove.hope this helps regards ...