...The crank sensor is on the front( bottom) of the engine behind the crank pulley, the pulley will have to be removed to access the sensor. It is the largest pulley directly in front of the oil
...I '[VE CHANGED THE COMPRESSOR AND DYER, AND IT'S STILL DOING IT The A/C belt just goes from the crank to the compressor. So if your snapping them then either there is a sharp edge on one of the ...
locate camshaft position sensor on 07 GMC Yukon XL 1500 5.3l Front of the engine above the crank pulley slightly to the right of center.
...first then the a/c belt , it has it's own tensioner. Just remember to take it off the crank pulley first and tuck it behind between the motor and pulley or you will be all day trying to get it
crank my car up and then it stops when the car warm up, i jus put a brand new belt on my car! what do i do? Try some bar soap on the belt before you start it for the squeal it is the alternator pulley
Question about 1996 Yukon
but instead kicks back at the starter as though the ignitioin wires are crosswired. Starts fine when warm. check the ignition timing on the crank pulley. Run the fault codes to check for sensor fault
Question about 1995 Yukon
Looking for crank sensor on my 95 Yukon. Its not near the starter, and not near front crank pulleys. Where else do I look? Could it be in the distributor, and what does it look like? The crank sensor ...
Usually answered in minutes!
593 Questions
524 Questions
309 Questions
326 Questions
238 Questions