crank shaft pulley ( the 4 Allen head bolts only not the 17mm bolt in the center.) remove the metal plate behind the engine mount bracket on the engine, remove the plastic timing belt cover 3 clips on
...pulley has only pick up coil on it no timing mark Thanks John Gold Coast Aussie Ibring piston to compression stroke. Apiece of tissue in the plug hole will blow out and then turn crank by hand until ...
...pulley(crank pulley) on twin cam engines on type lives in block under front engine mount air con compressor and power steering bracket the other lives in rear section of engine block (trans end) just ...
crank pulleys on lanos taken off son cannot remeber which is which help one has cicles other has oblong holes in hi, i believe you mean camshaft pulleys if so then the pulley with oblong holes goes on
...CRANK SHAFT PULLEY SAY THAT THERE ARE FOUR ALLAN HEADED BOLTS. AND ONE 17,MM BOLT IN THE CENTER. I HAVE NO ALLEN HEADED BOLTS JUST A 17MM CENTER BOLT. THE PULLEY ABOVE THE CRANKSHAFT PULLEY HAS FOUR ...
...means both intake and exhaust valves are shut when the crankshaft pulley mark line up to zero number on the timing cover plate near the crank pulley at the beginning of the job before
pulley has the mark does this line up with the mark on the plastic outer cover mark? The mark is on top, and the crank mark is on the bottom. The other two is; 1 is the waterpump pullley and the other
crank pulley screw. Note the direction the crankshaft rotates when the car is running. Position the breaker bar so that when you turn the key the breaker bar will hit the ground and cause the screw to
crank pulley for crankshaft sensor which is bolted in bracket attached to block near oil pressure switch, hopefully you didnt dent(bent) teeth on crank pulley from dropping it or putting pulley down a
1.5l SOHC. Can't find timing mark on crank pulley Replace the pulley then.
Usually answered in minutes!
554 Questions
540 Questions
410 Questions
304 Questions
