Questions & Answers for: Chevrolet Malibu crank pulley

...crank case pulley in a 2003 malibu to place a new timing cover and need to know how to remove the crank case pulley should have 3 or 4 bolts in the middle of pulley and just remove big bolt in center ...

crank case pulley for 1999 chevy malibu Replacing serpintine belt but belt keeps slipping off and was told that the crank case pulley was needing to be replaced. Is this the actual problem or is there

...front wheel and the splash shield, it should be there next to the pulley. the 3.1 engines crank shaft sensor is located behind crank shaft pulley.the 2.4 engine crank sensor is next to oil

what is the middle pulley called in the engine? The one connected to the crank shaft is called the damper. if it's strickly a pulley, then it's the idler

...in alignment with the rest. Some older model chevy V8s had a problem with the outer pulley of the vibration dampner( the crank shaft pulley) coming loose from the rubber connecting it to the inner. ...

...crank shaft pulley was out of alignment when i was changing the serpentine belt. when i tried to push it back on a rubber piece came out one side. so i pulled the whole thing off to reset the whole ...

crank pulley/harmonic ballencer is almost a half inch off from all other pulley on my 99 3.1 malibe the belt came off, so i checked the belt for wear and tear and decided it was definately a bad belt.

...crank pulley on the front of the motor. This pulley should be about 5 to 10 inches in diameter, and it usually is the pulley closest to the ground. It is on the front of the engine, but your engine ...

crank shaft pulley not aligned belt keeps on slipping off, seems like the crank shaft pulley is not aligned. what can be a salution You may have a bad bearing or bushing in one of the idler pulleys, ...

need to know if the crank shaft pulley is coming apart or missing the lock down nut. The ring on the outer edge of the pulley is held in place by molded rubber, I would think this will be your problem