Questions & Answers for: Mazda crank pulley

...crank pulley and replaced it with the new one in the same position, now the car will not start...any ideas as to why? you dont really need to mark your pulley. You need to set your crank pulley to 0 ...

...crank pulley I have a 1994 Lantis or Astina 2L V6 that has a bad coolant leak that occurs at the crank pulley...........what could this problem be? it is not the crank pulley it is the water pump ...

timing marks dohc the timing marks are located on the gear/pulley system. the crank pulley and the cam shaft pulley.

...crank pulley..u can take the 10 mm blots out of the timing belt/water pump covers.u will also need to support the engine(under the oli pan is ok) and remove the upper passenger side motor mount. 8. u ...

...part NO, the crank pulley, or harmonic balancer is rubber mounted, it will come apart, and is a fairly expensive item, $100 at the junk yard. Get it fixed before it flies off the car. Hope this

crank shaft pulley on 2001 mazda 626 You have to partially unscrew the bolt in the center, that's holding the pulley to the crankshaft. Then, you have to use a puller to safely pull, without damaging,

...crank pulley. Turn the crank further until the screw-driver starts moving downwards. Stop immediately and make another mark on the crank pulley. TDC would be right in the middle of the two marks, and ...

altenater pulley appears to be misalinged on 1999 mazda protege causing belt breakage Bad crank damper pulley,not alternator unless you just replaced & got the wrong pulley

...Crank shaft pulley was installed, then Mazda Tribute 2.3lL won't start New A/C compressore was installed along with a new crankshaft pulley. NOw it won't start. Any ideas check for damage /wire ...

...belt does not stay on Crankshaft Pulley when I start engine. I put serpentine belt back in place and it comes off again. what is the condition of the crank pulley? is it coming off the rubber