Questions & Answers for: GMC crank pulley

...The crank sensor is on the front( bottom) of the engine behind the crank pulley, the pulley will have to be removed to access the sensor. It is the largest pulley directly in front of the oil

...crank bolt to remove timing cover. please help you need an air impact gun to get retaining bolt out/off, then a pulley puller special tool to remove the pulley once the bolt is out, the pulley is ...

...crank the engine a few times to get the hole to line up with the sensor so you can lift it straight out. Hi, Location on 2WD 95 Jimmy 4.3L Cpl 3 Cylinder is :- Under hood, center, front engine area, ...

...Pulley. 3) Crank Pulley (Vibration Dampner) sounds like somthing is out of line ,remove belt and check all the pulleys spin freely and without noise,also when a belt overheats due to being over ...

were is the crank sensor located on a 2002 ENVOY behind cranksharft pulley pulley at the bottom not sure if you knew not triing to sound like a wise guy

...If you mean the crank shaft pulley then yes you have to remove to remove the timing cover.Hop[e this helps.Good luck. Yes. You need to remove dampener pulley to get timing cover off to get to

...crank pulley.  You should be able to tell if it goes around a pulley if you have empty pulley grooves.Most V8 GM engines ran the AC belt around the crank and the water pump, but it depends on ...

...know where to find it. The crank sensor bolts into the front timing cover right underneath the crank pulley. If you look at the vehicle from underneath, you'll be able to see it... very common ...

...Crank Pulley If you have a Johnson bar and socket on the crank pulley bolt you should be able to turn the motor over by torquing in a clockwise direction. If you encounter excess resistance, remove ...

...crank sensor at the front under the front crank pulley and it is in the correct installed position, you should not have a code for that,unless the wiring is defective or the crank sensor is