Questions & Answers for: Jeep Wrangler crank position sensor located 97

Question about 1992 Wrangler

1 Answer

Crank Position Sensor Where is the Crank Position Sensor (CPS) located on a 92 jeep wrangler? wall5552: there were two engines used in 1992 Jeep Wranglers. A 2.5 liter and a 4.0 liter. HOWEVER>>

Ad

...mark on crank pulley at tdc. Running timing changes are made by the computer using info from the crank sensor, throttle position sensor, map sensor and cam sensor (inside the distributor

Ad

Question about 1998 Wrangler

1 Answer

Crank (shaft position) reference signal detected during engine cranking (starting). P 1391 =Intermittent Loss of either Camshaft Position Sensor or Crankshaft Position Sensor. Hav you attemtped the "3

Question about 1992 Wrangler

1 Answer

...it bad/in wrong position/or the bell housing holds the crank sensor to far away from flywheel.if my memory is correct anything other than the jeep bellhousing wont work with the jeep fuel ign. ...

For 1997 Jeep Wrangler 4WD 4.0L MFI 6cyl the Camshaft Position Sensor is located: Under hood, passenger side, front engine area, mounted on front of intake manifold Hope helps (remember to rate this)

Question about 1997 Wrangler

1 Answer

crank position) sensor Probably start with changing the crank sensor. But keep in mind that the high charging system voltage may be causing the other electrical sensor problems. The voltage regulator

Question about 1994 Wrangler

1 Answer

...crank position, cam position, installed new distributor assembly, new plugs, wires, coil... still cannot find solution.. Throttle position sensors on 4.0 Jeeps are very touchy and erratic at best, ...

Question about 1997 Wrangler

1 Answer

...plugs,cap rotor,new coil,good battery,fuel a that stuff checks out.But still have no spark ...it cranks no problem but i have nothing.Any ideas on what i`m missing . replace the crank position ...

...crank no start condition but you have not performed any fault code testing or at least you didn't mention you did. To obtain instructions on how to perform a OBD1 fault code ...

...Crank Shaft Position Sensor locate and test Crankshaft Position Sensor CPS Replacement 99 Jeep Wrangler Sahara How to Test Crankshaft and Camshaft Position Sensors left side back of engine at the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...