Questions & Answers for: Hyundai Santa Fe crank position sensor located 97

Question about 2004 Santa Fe

2 Answers

crank position sensor When driving my car it will dye and restart. If sits for at least 1/2 hour or longer will start again. This keeps reaccuring. We were told it was the crank postion sensor. how do

Ad

Question about 2004 Santa Fe

2 Answers

...crank position sensors which read a reluctor ring integral to the Harmonic Balancer. This is a much more accurate method of determining the position of the crankshaft, and allows the computer to ...

Ad

...crank position sensor 2003 santa fe 4 cylinder hi the sensor is in with the timing belt. You will have to remove the timing belt cover and belt to put a new one in. You will also see a small gold ...

...position sensor to be either defective, or not connected well to the wiring or the trigger wheel could have damage, i need to know where this sensor is so i can either replace it or make sure it is ...

my 97 cavalier will die after being driven for a while. someone said it is a sensor located behind the coil pack. i need to know what this sensor is called. MAP Sensor Crank Shaft Position Sensor

crank sensor will let car run for a while then shut down and will not start for 10 to 15 min. and it will repeat this cycle if not fixed.the crankshaft position sensor provides the ignition module and

Position Sensor "B". Other crank sensor codes include P0016, P0017, P0018, P0019, P0335, P0336, P0337, P0338, P0339, P0385, P0386, P0387, P0388, and P0389. P1372 - Segment Time IncorrectThis engine is

Question about 2004 Santa Fe

2 Answers

...position sensor. Using a digital multimeter and with the key in the RUN position, check the Green wire for 5 volts (pos lead from meter to green wire, neg lead to ground). Then check the black/white ...

Question about 2002 Santa Fe

1 Answer

...position sensor on the 4 cylinder and the 3.5L V6 are in the same place - Front Crank Shaft behind the pully (behind the timing belt cover. On the 2.7L V6, the Cranshaft Position Sensor is located in ...

crank shaft position sensor on a 2007 hyundai santa fe 3.3 cant find location located on the bell housing of the transmission under left cylinder head or radiator side of engine

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...