Questions & Answers for: Buick LeSabre crank position sensor located 97

...Position Sensor, they go open circuit when they get hot, then after it cools it becomes a good circuit again, this is very frustrating, had the same issue with my Buick a few years ago, replaced the ...

...crank sensor is located at the crank pulley it sits inside and creates a magnetic field and produces a low ac voltage 5 ac volts or less module then converts it to a squar wave to fire injectors and ...

...position sensor is located behind the crank balancer (at the center of the engine behind the big pulley at the bottom) That year has a special removal tool to pull the balancer. What isssue are you ...

...position sensor located? 1998 Buick Lesaber with 3.8L Issue is Car will turnover but not crank on hot days only. In the morning the car will start every time but later during the day it wont start. I ...

crank position sensor trying to locate the Crank position sensor on a 1988 Buick LeSabre The crankshaft position sensor should be located behind the vibration damper/harmonic balancer and it will have

...crank position sensor has gone bad. When this sensor goes bad, the PCM can't read the appropriate speeds of the crankshaft, and will adjust the fuel and air mixture to compensate, often times the ...

...ago spark plug replacement, and 2 weeks ago crank shaft position sensor replacement. Have you checked the catalytic converter? After 20 years they do pug up causing some of the problems you ...

...crank position sensor, can short the starter out and it will run about 60 seconds. Will it only crank with the starter shorted, and not with the key? Did you do or have a Crank sensor Variation Learn ...

crank sensor is an electronic device used in an internal combustion engine to monitor the position or rotational speed of the crankshaft. Good-Day! You probably mean a Crankshaft Position Sensor. This

position. Failure to do this will result in the new sensor and/or the crank pulley being severely damaged. Then it's as simple as removing the old sensors and installing the new one. Good luck and let